Revel lcr8 Guia Do Utilizador
4
Tilting the Speaker
If needed, the enclosed stand allows you to tilt the
speaker across a wide range (i.e., upward to a maximum
of 18° or downward to a maximum of 7°), as shown in
Figure 3.
speaker across a wide range (i.e., upward to a maximum
of 18° or downward to a maximum of 7°), as shown in
Figure 3.
Important! Do not exceed the tilt range.
Doing so may cause the speaker to fall out
of its stand.
Doing so may cause the speaker to fall out
of its stand.
Figure 3
Wall-Mounting the LCR8
Using the Included Wall Bracket
Step One
Remove the wall bracket cover by removing the four
wall-bracket screws on the ends, as shown.
wall-bracket screws on the ends, as shown.
Step Two
Run the speaker wire for the left, center and right channels
behind the wall bracket and out through the holes in the
bracket. After deciding where to place the speaker, attach
the wall bracket (in a horizontal position) to the wall, using
the appropriate screws and anchors.
behind the wall bracket and out through the holes in the
bracket. After deciding where to place the speaker, attach
the wall bracket (in a horizontal position) to the wall, using
the appropriate screws and anchors.
Step Three
Run the speaker wires out through the holes in the wall
bracket cover. Resecure in place, as shown, with the four
wall bracket screws.
bracket cover. Resecure in place, as shown, with the four
wall bracket screws.
Mounting screws and
anchors not included
anchors not included
Wall bracket
HSGP1054-LCR8_OM 9/12/08 12:42 PM Page 4