Revel f30 Guia Do Utilizador
Figure 7. Wire gauge versus
maximum wire run (with a
maximum loop resistance of
0.07 ohms) for less than 0.2 dB
response error.
maximum wire run (with a
maximum loop resistance of
0.07 ohms) for less than 0.2 dB
response error.
NOTE: “Loop resistance” is the
DC resistance measured at one
end of a loudspeaker cable, with
the other ends shorted together.
DC resistance measured at one
end of a loudspeaker cable, with
the other ends shorted together.
CONNECTIONS
REVEL PERFORMA F30 loudspeakers can be connected to
your audio system in three different ways: single-wired, bi-wired, or
bi-amplified. Please read the following three sections before pro-
ceeding with the actual connections. Also, be sure to observe the
following points:
your audio system in three different ways: single-wired, bi-wired, or
bi-amplified. Please read the following three sections before pro-
ceeding with the actual connections. Also, be sure to observe the
following points:
• Use high-quality speaker cable with a maximum total loop resis-
tance (for each wire run) of 0.07 ohms or less. Use the chart in
Figure 7 below to determine the maximum wire gauge.
Figure 7 below to determine the maximum wire gauge.
NOTE: A high loop resistance will result in mis-termination
of the filter networks, and serious degradation of sound
quality. Use high-quality connectors on the speaker cables.
Consult your Revel dealer as to specific recommendations for
your application.
of the filter networks, and serious degradation of sound
quality. Use high-quality connectors on the speaker cables.
Consult your Revel dealer as to specific recommendations for
your application.
• Turn off all audio system power before making any connections.
• Read the owner’s manuals that were included with your audio
components to confirm their connection procedures.
• Verify correct polarities (i.e.,
+
to
+
and
−
to
−
) when making
connections. Failure to do so will cause poor imaging and
diminished bass response.
diminished bass response.
• For bi-wired or bi-amplified applications, remove the shorting
straps on the rear of each REVEL PERFORMA F30 loudspeak-
er (refer to Figures 9, 10, and 11 on the next three pages).
er (refer to Figures 9, 10, and 11 on the next three pages).
REVEL PERFORMA F30
Owner’s Manual
12
W
IRE
G
AUGE
(AWG) L
ENGTH
(
FEET
)
L
ENGTH
(
METERS
)
6
87
27
7
69
21
8
58
18
9
43
13
10
34
10
11
27
8
12
22
7
13
17
5
14
14
4
15
11
3
16
9
3
17
7
2
18
5
2