Revel ic6t2 Guia Do Utilizador
Figure 2. The VOICE transducer
and connection locations.
and connection locations.
DESCRIPTION
The Ultima VOICE center-channel speaker uses two 8-inch mica
and carbon-filled copolymer woofers to reproduce the lower
octaves. A 4-inch titanium transducer reproduces the very impor-
tant midrange frequencies. A 1-inch textile-dome tweeter repro-
duces higher frequencies.
and carbon-filled copolymer woofers to reproduce the lower
octaves. A 4-inch titanium transducer reproduces the very impor-
tant midrange frequencies. A 1-inch textile-dome tweeter repro-
duces higher frequencies.
Combined with an individually-optimized crossover network, this
transducer arrangement provides a uniform “listening window” or
area in which the sound varies little. Also, the large woofer size is
used to reproduce center channel information and all its dynamics
without compression.
transducer arrangement provides a uniform “listening window” or
area in which the sound varies little. Also, the large woofer size is
used to reproduce center channel information and all its dynamics
without compression.
MIDRANGE
To ensure accurate detail, each VOICE speaker has a 4-inch
midrange that is unique in the following ways:
midrange that is unique in the following ways:
• The midrange’s radiating surface is made of titanium for true
pistonic behavior throughout its operating range.
• The midrange’s motor system utilizes neodymium magnets with a
stray-flux containment system for shielding near video monitors.
• The cast magnesium frame provides optimum voice coil cooling
and minimum reflections, while offering excellent rigidity.
WOOFERS
To ensure uncompressed dynamic range, each VOICE speaker uses
a pair of 8-inch woofers that are unique in the following ways:
a pair of 8-inch woofers that are unique in the following ways:
• The woofer’s radiating surface is made of an injection-molded
polymer material with incredible stiffness and internal damping.
• Optimized magnetic circuits to minimize harmonic distortion.
VOICE Speaker
Owner’s Manual
4
Install straps for
single-wired operation
Note:
Remove straps
for bi-wired
or bi-amplified
operation
Remove straps
for bi-wired
or bi-amplified
operation
Install straps for
single-wired operation
Low Frequency Input
High Frequency Input
High Frequency
Level (dB)
0
+.5
-.5
+1
-1
Placement
Compensation
(See Owner's Manual)
Compensation
(See Owner's Manual)
Serial Number
Revel Corporation
Chatsworth, California
Made in U.S.A.
Chatsworth, California
Made in U.S.A.
On Top Of
Monitor
Flush
Mounted
Stand
Mounted
Mounted
VOICE Front
VOICE Rear
Woofer
Tweeter
Midrange
Woofer
High-Frequency
Level Control
Level Control
Placement
Compensation
Control
Connectors (with
shorting straps)