Revel ic6t2 Guia Do Utilizador

SPEAKER CONNECTIONS

The VOICE center-channel speaker can be connected to your audio
system in three different ways: single-wired, bi-wired or bi-amplified.
Please read the following three sections before proceeding with the
actual connections. Also, be sure to observe the following points:

• Use high-quality speaker cable (maximum total loop resistance

of 0.1 ohms per channel) with high-quality connectors between
the speaker and your audio system. Consult your Revel dealer as
to specific recommendations for your application.

• Turn off all audio system power before making any connections.

• Read the owner’s manuals that were included with your audio

components to confirm their connection procedures.

• Verify correct polarities (i.e., + to + and - to -) when making

connections. Failure to do so will cause poor imaging and
diminished bass response.

• For bi-wired or bi-amplified applications, remove the shorting

straps on the rear of the VOICE speaker (refer to Figures 7, 8,
and 9 on the next three pages).

SINGLE-WIRED SYSTEM CONNECTIONS

For most applications, simply leave the shorting straps in place and
connect the 

+

and 

−

from a single amplifier channel to the HIGH

FREQUENCY INPUT terminals on the rear of the speaker, as
shown in Figure 6.

VOICE Rear

Amplifier

(rear)

(one channel shown)

white

red

Connector Panel

Shorting Straps

(leave in place)