Revel salon Guia Do Utilizador

Figure 7. Tilting a SALON
and installing a pair of spikes.

INSTALLING SPIKES

After choosing a final placement, add the spikes (and covers, if
desired) by performing the following steps:

1. Remove spike feet and locking rings from the plastic bags.

2. Enlist the aid of friend to tilt a SALON to one side and start a

pair of spikes, as shown in Figure 7. Use caution to avoid
touching the front tweeter and midrange. The tip of the spike
should extend about 1

⁄

" from the bottom of the cabinet.

3. Assemble and tighten locking rings onto the front spikes.

4. Tilt the SALON in the other direction and install the other pair

of spikes in the same manner.

NOTE: If the speaker is to be used on a hardwood or tile floor, use
supplied spike covers. Further adjustment of spike may be necessary
due to uneven floors.

5. Repeat steps 1 through 4 for the other SALON.

SALON

Owner’s Manual

,,,

,,,,,,,,,

,,,,,,,,

,,,,,,,,,

,,,,,,,

Locking
Ring

Spike

Cover

(for hardwood
or tile floor)

(Optional) Use Covers For

Hardwood Or Tile Floor

⁄