Revel salon Guia Do Utilizador
Figure 13. The SALON level
control locations and
initial settings.
control locations and
initial settings.
SYSTEM OPTIMIZATION
1. After connecting the SALON speakers, initially set both
HIGH FREQUENCY LEVEL controls on both rear panels to
the “0” position, as shown in Figure 13.
the “0” position, as shown in Figure 13.
2. Set the LF COMPENSATION control as follows (refer to
Figure 13):
• Use the “0” setting during initial setup.
• Use the “+” setting to increase the bass level, centered around
50 Hz (see Figure 14 on the next page), if low frequencies
are insufficient.
are insufficient.
• Use the “–” setting to decrease the bass level, if low frequen-
cies are too pronounced.
3. Turn on the system power and play a favorite piece of music.
Slowly increase the volume to a comfortable level and listen
from your main listening position. If desired, experiment with
placement (see page 8) to achieve the best overall tonal balance,
image specificity, and spaciousness.
from your main listening position. If desired, experiment with
placement (see page 8) to achieve the best overall tonal balance,
image specificity, and spaciousness.
SALON
Owner’s Manual
16
Install straps for
single-wired operation
Remove straps
for bi-wire
or bi-amp
for bi-wire
or bi-amp
Install straps for
single-wired operation
Low Frequency Input
High Frequency Input
Revel Corporation
Chatsworth, California
Made in U.S.A.
Chatsworth, California
Made in U.S.A.
Serial Number
TM
0
-3
Off
+1
-1
0
+.5
-.5
Front Tweeter Level
Rear Tweeter Level
0
+
LF Compensation
xxxx
Install straps for
single-wired operation
single-wired operation
Remove straps
for bi-wire
or bi-amp
for bi-wire
or bi-amp
Install straps for
single-wired operation
single-wired operation
Low Frequency Input
High Frequency Input
Revel Corporation
Chatsworth, California
Made in U.S.A.
Chatsworth, California
Made in U.S.A.
Serial Number
TM
0
-3
Off
+1
-1
0
+.5
-.5
Front Tweeter Level
Rear Tweeter Level
0
+
LF Compensation
xxxx
Set Both Tweeter
Level Controls
To “0”
Set LF Compensation
Control To “0”
Control To “0”
SALON
Rear
Connector
Panel