Crate fw120 Guia Do Utilizador

FlexWave120/212 Guitar Amplifier w/DSP and Channel Tracking

Your Crate FlexWave120/212 gives you the power of Channel Tracking. Once you select a 
DSP setting for each channel, Channel Tracking stores the settings to memory whenever you 
change channels. When you go back to that channel, Channel Tracking recalls those DSP set-
tings automatically, without changing the DSP controls!
For example:
•  Select the Clean channel. Set the Mod control to “Flanger,” the Delay control to “Medium,” 

and adjust the Reverb control to your preference.

•  Select the Overdrive channel. Set the Mod control to “Chorus,” the Delay control to “Slap,” 

and readjust the Reverb control to a different setting. (The DSP settings for the Clean 
channel are now saved to memory.)

•  Select the High Gain channel. Set the Mod control to “Phaser,” the Delay control to “Long,” 

and readjust the Reverb control once again. (The DSP settings for the Overdrive channel 
are now saved to memory.)

•  Reselect the Clean channel. (The DSP settings for the High Gain channel are now saved to 

memory.)

When you reselected the Clean channel, the DSP settings previously stored in memory were 
automatically recalled. Switch to the Overdrive channel and the DSP settings you just stored 
are still there. You can change the DSP settings at any time. Once you set the DSP and select 
another channel, Channel Tracking stores the settings for you. Even when the amplifier is 
turned off, the DSP settings are stored and recalled the next time you turn it on. That’s the 
power of Channel Tracking!
In addition, each channel has two DSP banks, Bank A and Bank B, when you use the supplied 
three-button footswitch (see page 8 for more information on using the footswitch). Channel 
Tracking also remembers which DSP bank was selected for each channel.