Panasonic PV-DV103 Guia Do Utilizador
46
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Editing Features
3, 4
PLAY
3, 4, 5
PAUSE
3, 4
PLAY
6
STOP
4
REC
High quality digital-to-digital copying can be
accomplished if both Palmcorders incorpo-
rate the DV Input/Output (i.LINK) Connec-
tor (DV Interface cable (i.LINK) is not
supplied).
accomplished if both Palmcorders incorpo-
rate the DV Input/Output (i.LINK) Connec-
tor (DV Interface cable (i.LINK) is not
supplied).
1
Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
source (playing) Palmcorder, and set
POWER to VCR.
2
Insert a blank tape with the record
tab closed into the target (recording)
Palmcorder and set POWER to VCR.
tab closed into the target (recording)
Palmcorder and set POWER to VCR.
3
Press (PLAY) on the source
Palmcorder. When the tape reaches
the point you want to start dubbing,
press (PAUSE).
Palmcorder. When the tape reaches
the point you want to start dubbing,
press (PAUSE).
4
Hold down (REC) and press
(PLAY) on the target (recording)
Palmcorder or on the remote control
(optional).
Press (PAUSE) to pause the tape at
the starting point of the dub.
(optional).
Press (PAUSE) to pause the tape at
the starting point of the dub.
5
Simultaneously, press (PAUSE) on
both units to begin dubbing.
both units to begin dubbing.
6
Press (STOP) on the recording
unit, and then press (STOP) on the
playing unit to end dubbing.
unit, and then press (STOP) on the
playing unit to end dubbing.
• When two Palmcorders are used for
dubbing, it is recommended that the
Remote Control (optional) VCR1 or VCR2
setting be used to avoid improper-
operation.
Remote Control (optional) VCR1 or VCR2
setting be used to avoid improper-
operation.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
copying of copyrighted recordings may
be copyright infringement.
Source (Playing)
Palmcorder
Palmcorder
Recording
Palmcorder
Palmcorder
DV Interface
Cable (i.LINK)
(optional)
Cable (i.LINK)
(optional)
DV Input/Output
(i.LINK) Connector
(i.LINK) Connector
Copying from Digital
Equipment (dubbing)
Equipment (dubbing)
Note
3, 4, 5
PAUSE
Before you begin
• Connect both Palmcorders to their
power sources.
• Connect the two Palmcorders using the
DV Interface cable (i.LINK)
(4-pin to 4-pin).
(4-pin to 4-pin).
• Turn both Palmcorders ON.
6
STOP
4
REC
Optional
DV103.p43-46.p65
03/02/07, 10:49
46