WatchGuard x1000 Guia Do Utilizador
Running the QuickSetup Wizard
User Guide
41
Provide the information as prompted by the QuickSetup
Wizard, referring to the tables and network diagrams in
“Gathering Network Information” on page 24.
Wizard, referring to the tables and network diagrams in
“Gathering Network Information” on page 24.
The QuickSetup Wizard takes you through the following
steps:
steps:
Select a configuration mode
Specify whether you want a routed or a drop-in
configuration mode. If you have High Availability
installed, it is recommended that you set this up
using Policy Manager instead of the QuickSetup
Wizard. For more information on routed or drop-
in, see “Selecting a Firewall Configuration Mode”
on page 28. For information on High Availability,
see the High Availability Guide.
configuration mode. If you have High Availability
installed, it is recommended that you set this up
using Policy Manager instead of the QuickSetup
Wizard. For more information on routed or drop-
in, see “Selecting a Firewall Configuration Mode”
on page 28. For information on High Availability,
see the High Availability Guide.
External interface configuration
(Routed configuration only.) Specify static, DHCP,
or PPPoE, as explained in “Dynamic IP support on
the external interface” on page 35.
or PPPoE, as explained in “Dynamic IP support on
the external interface” on page 35.
Enter the Firebox interface IP address or addresses
Based on whether you specified routed or drop-in
mode, enter the IP address or addresses for the
Firebox interfaces. You can also add a secondary
network to your trusted interface by selecting the
additional private network behind the Firebox
checkbox.
mode, enter the IP address or addresses for the
Firebox interfaces. You can also add a secondary
network to your trusted interface by selecting the
additional private network behind the Firebox
checkbox.
Enter the Firebox Default Gateway
(Not applicable if using DHCP or PPPoE on the
external interface.) Enter the IP address of the
default gateway, which is usually the IP address of
your Internet router. This IP address must be on
the same network as the Firebox external interface.
If the IP address is not on the same network, the
QuickSetup Wizard will warn you and ask
whether you want to continue.
external interface.) Enter the IP address of the
default gateway, which is usually the IP address of
your Internet router. This IP address must be on
the same network as the Firebox external interface.
If the IP address is not on the same network, the
QuickSetup Wizard will warn you and ask
whether you want to continue.
Configure Public Servers
(Not applicable if using DHCP or PPPoE on
external interface.) Select the checkbox and enter
external interface.) Select the checkbox and enter