3com 5500-ei pwr Instrução De Instalação

 

1-19 

Follow these steps to specify the current switch as the secondary root bridge of a spanning tree: 

Enter system view 

— 

Specify the current switch as 
the secondary root bridge of a 
specified spanning tree 

[ instance instance-id ] root 

[ bridge-diameter 

 [ hello-time 

 ] ] 

Required 

 

Using the stp root primary/stp root secondary command, you can specify the current switch as the 
root bridge or the secondary root bridge of the MSTI identified by the instance-id argument. If the value 
of the instance-id argument is set to 0, the stp root primary/stp root secondary command specify the 
current switch as the root bridge or the secondary root bridge of the CIST. 

A switch can play different roles in different MSTIs. That is, it can be the root bridges in an MSTI and be 
a secondary root bridge in another MSTI at the same time. But in the same MSTI, a switch cannot be 
the root bridge and the secondary root bridge simultaneously. 

When the root bridge fails or is turned off, the secondary root bridge becomes the root bridge if no new 
root bridge is configured. If you configure multiple secondary root bridges for an MSTI, the one with the 
smallest MAC address replaces the root bridge when the latter fails. 

You can specify the network diameter and the hello time parameters while configuring a root 
bridge/secondary root bridge. Refer to 

 and 

 for information about the network diameter parameter 

and the hello time parameter. 

 

z

 

You can configure a switch as the root bridges of multiple MSTIs. But you cannot configure two or 
more root bridges for one MSTI. So, do not configure root bridges for the same MSTI on two or 
more switches using the stp root primary command. 

z

 

You can configure multiple secondary root bridges for one MSTI. That is, you can configure 
secondary root bridges for the same MSTI on two or more switches using the stp root secondary 
command. 

z

 

You can also configure the current switch as the root bridge by setting the priority of the switch to 0. 
Note that once a switch is configured as the root bridge or a secondary root bridge, its priority 
cannot be modified. 

 

# Configure the current switch as the root bridge of MSTI 1 and a secondary root bridge of MSTI 2. 

<Sysname> system-view 

[Sysname] stp instance 1 root primary 

[Sysname] stp instance 2 root secondary