3com 5500-ei pwr Instrução De Instalação
2-3
z
Use the ip route-static command to configure a default route by setting the destination IP address
and the mask to 0.0.0.0.
z
Avoid configuring the next hop address of a static route to the address of an interface on the local
switch.
z
Different preferences can be configured to implement flexible route management policies.
z
For automatic detection information, refer to the part discussing Auto Detect.
Displaying and Maintaining Static Routes
To do...
Use the command...
Remarks
Display the current configuration
information
information
display current-configuration
Display the brief information of a
routing table
routing table
display ip routing-table
Display the detailed information of a
routing table
routing table
display ip routing-table verbose
Display the information of static
routes
routes
display ip routing-table protocol static
[ inactive | verbose ]
[ inactive | verbose ]
Available in
any view
any view
Delete all static routes
delete static-routes all
Available in
system view
system view
Static Route Configuration Example
Network requirements
A small company requires that any two nodes in its office network communicate with each other, and
that the network structure be simple and stable. The company hopes that the existing devices that do
not support any dynamic routing protocol can be fully utilized.
In this case, static routes can implement communication between any two nodes.
Network diagram
According to the network requirements, the network topology is designed as shown in