3com 5500-ei pwr Instrução De Instalação

 

3-12 

 

Only the configuration related to RIP is listed below. Before the following configuration, make sure the 

Ethernet link layer works normally and the IP addresses of VLAN interfaces are configured correctly. 

 

1)  Configure Switch A: 

# Configure RIP. 

<SwitchA> system-view 

[SwitchA] rip 

[SwitchA-rip] network 110.11.2.0 

[SwitchA-rip] network 155.10.1.0 

2)  Configure Switch B: 

# Configure RIP. 

<SwitchB> system-view 

[SwitchB] rip 

[SwitchB-rip] network 196.38.165.0 

[SwitchB-rip] network 110.11.2.0  

3)  Configure Switch C: 

# Configure RIP. 

<SwitchC> system-view 

[SwitchC] rip 

[SwitchC-rip] network 117.102.0.0 

[SwitchC-rip] network 110.11.2.0 

The Ethernet switch cannot receive any RIP update when the physical connection between the switch 

and the peer routing device is normal. 

Check that: 

z 

RIP is enabled by using the network command on the corresponding interface. 

z 

The interface is allowed to receive or send RIP packets. 

z 

The interface receives RIP packets in the way the peer device sends them, for example, in the 

broadcast or multicast mode.