3com 5500-ei pwr Instrução De Instalação

 

1-29 

Configure the current port as a 
source mirroring port 

mirrored-to { inbound | 
outbound } acl-rule 
{ monitor-interface | cpu }

Required 

Omit the following 
steps if you redirect 
traffic to the CPU. 

Proceed to the 
following steps if 
you redirect traffic 
to a port. 

Quit to system view 

— 

In system 
view 

mirroring-group group-id 
monitor-port 
monitor-port-id 

interface interface-type 
interface-number 

Configure the 
specified port as the 
destination 
mirroring port 

In Ethernet 
port view 

Required 

Use either 
approach.  

 

For information about the mirroring-group monitor-port command and the monitor-port 

command, refer to the part talking about mirroring.  

 

Network requirements: 

z 

Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment. 

z 

Duplicate the packets from network segment 10.1.1.0/24 to the destination mirroring 

port Ethernet 1/0/4. 

Configuration procedure: 

<Sysname> system-view 

[Sysname] acl number 2000 

[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255 

[Sysname-acl-basic-2000] quit 

[Sysname] interface Ethernet1/0/4 

[Sysname-Ethernet1/0/4] monitor-port 

[Sysname-Ethernet1/0/4] quit 

[Sysname] interface Ethernet1/0/1 

[Sysname-Ethernet1/0/1] mirrored-to inbound ip-group 2000 monitor-interface