3com 5500-ei pwr Instrução De Instalação

 

1-8 

Configure trunk port to 
permit packets from the 
remote-probe VLAN  

port trunk permit vlan 
remote-probe-vlan-id 

Required 

Return to system view 

— 

Create a remote destination 
mirroring group 

mirroring-group group-id 
remote-destination 

Required 

Configure the destination 
port for the remote 
destination mirroring group 

mirroring-group group-id 
monitor-port monitor-port 

Required 

Configure the remote-probe 
VLAN for the remote 
destination mirroring group  

mirroring-group group-id 
remote-probe vlan 
remote-probe-vlan-id 

Required 

 

When configuring a destination switch, note that: 

z 

A Switch 5500-EI acting as the destination switch in remote port mirroring networking 

does not support bidirectional packet mirroring (the both keyword). 

z 

The destination port of remote port mirroring cannot be a member port of an existing 

mirroring group, a fabric port, a member port of an aggregation group, or a port enabled 

with LACP or STP. 

z 

Only an existing static VLAN can be configured as the remote-probe VLAN. To remove 

a remote-probe VLAN, you need to restore it to a normal VLAN first. A remote port 

mirroring group gets invalid if the corresponding remote port mirroring VLAN is 

removed. 

Display port mirroring 
configuration on a Switch 
5500-EI 

display mirroring-group 
{ group-id | all | local | 
remote-destination | 
remote-source } 

Available in any 
view 

 

The departments of a company connect to each other through Switch 5500-EI: 

z 

Research and Development (R&D) department is connected to Switch C through 

Ethernet 1/0/1. 

z 

Marketing department is connected to Switch C through Ethernet 1/0/2. 

z 

Data detection device is connected to Switch C through Ethernet 1/0/3