3com 5500-ei pwr Instrução De Instalação

 

1-9 

TFTP server program is not provided with the 3Com Series Ethernet Switches. 

 

Step 3: Run the HyperTerminal program on the configuration PC. Start the switch. Then enter the BOOT 

Menu. 

At the prompt "Enter your choice(0-9):" in the BOOT Menu, press <6> or <Ctrl+U>, and then press 

<Enter> to enter the Boot ROM update menu shown below: 

Bootrom update menu: 

1. Set TFTP protocol parameter 

2. Set FTP protocol parameter 

3. Set XMODEM protocol parameter 

0. Return to boot menu 

 

Enter your choice(0-3): 

Step 4: Enter 1 in the above menu to download the Boot ROM using TFTP. Then set the following 

TFTP-related parameters as required: 

Load File name           :Switch.btm 

Switch IP address        :1.1.1.2 

Server IP address        :1.1.1.1 

Step 5: Press <Enter>. The system displays the following information: 

Are you sure to update your bootrom?Yes or No(Y/N) 

Step 6: Enter Y to start file downloading or N to return to the Boot ROM update menu. If you enter Y, the 

system begins to download and update the Boot ROM. Upon completion, the system displays the 

following information: 

Loading........................................done 

Bootrom updating..........done! 

Follow these steps to load the host software. 

Step 1: Select <1> in BOOT Menu and press <Enter>. The system displays the following information: 

1. Set TFTP protocol parameter 

2. Set FTP protocol parameter 

3. Set XMODEM protocol parameter 

0. Return to boot menu 

 

Enter your choice(0-3): 

Step 2: Enter 1 in the above menu to download the host software using TFTP. 

The subsequent steps are the same as those for loading the Boot ROM, except that the system gives 

the prompt for host software loading instead of Boot ROM loading.