3com 5500-ei pwr Guia De Referência

 

5-20 

The ports configured with this command handle Layer 2 multicast traffic only, rather than Layer 3 

multicast traffic. 

 

# Configure ports Ethernet 1/0/1 to Ethernet 1/0/3 under VLAN-interface 1 as static members ports for 

multicast group 225.0.0.1. 

<Sysname> system-view 

System View: return to User View with Ctrl+Z. 

[Sysname] interface Vlan-interface 1 

[Sysname-Vlan-interface1] multicast static-group 225.0.0.1 interface Ethernet 1/0/1 to 

Ethernet 1/0/3 

multicast static-group group-address vlan vlan-id 

undo multicast static-group group-address vlan vlan-id 

Ethernet port view 

group-address: IP address of the multicast group to join, in the range of 224.0.0.0 to 239.255.255.255. 

vlan vlan-id: Specifies the VLAN the Ethernet port belongs to, where vlan-id ranges from 1 to 4094. 

Use the multicast static-group vlan command to configure the current port as a static member port for 

the specified multicast group and specify the VLAN the port belongs to. 

Use the undo multicast static-group vlan command to remove the current port in the specified VLAN 

as a static member port for the specified multicast group. 

By default, no port is configured as a static multicast group member port.  

Note that: 

The impact of the configuration depends on whether the current port belongs to a multicast VLAN and 

whether the port belongs to the specified VLAN. 

z 

If the current port belongs to neither a multicast VLAN nor the specified VLAN, the configuration 

does not take effect.  

z 

If the current port does not belong to any multicast VLAN but it belongs to the specified VLAN, the 

configuration takes effect in the specified VLAN.  

z 

If the current port belongs to a multicast VLAN, the configuration takes effect only in the multicast 

VLAN no matter the port belongs to the specified VLAN or not.