3com 8807 Guia De Referência
PIM Configuration Commands
627
In addition, this command can also display the BSR and static RP information.
Example
# View the RP information of multicast group.
<SW8800> display pim rp-info
PIM-SM RP-SET information:
BSR is: 20.20.20.20
Group/MaskLen: 224.0.0.0/4
RP 20.20.20.20
Version: 2
Priority: 0
Uptime: 00:00:05
Expires: 00:02:25
Adv-Period: 60 seconds
Holdtime: 150 seconds
The following table details the display information.
pim
Syntax
pim
undo pim
View
System view
Parameter
None
Description
Use the pim command to enter the PIM view and configure the PIM global
parameters. Note that the command does not enable the PIM protocol.
parameters. Note that the command does not enable the PIM protocol.
Use the undo pim command to return to system view, clear the PIM global
parameters configured before and clear the PIM view.
parameters configured before and clear the PIM view.
Table 91 Description on the fields of display pim rp-info
Field
Description
PIM-SM RP-SET information:
RP information
BSR is: 4.4.4.6
BSR is the virtual interface of the node 4.4.4.6.
Group/MaskLen: 224.0.0.0/4
RP 4.4.4.6
Version: 2
Priority: 0
Uptime: 00:39:50
Expires: 00:01:40
Adv-Period: 60 seconds
Holdtime: 150 seconds
The RP with IP address 224.0.0.0 and mask length of 4 is the
virtual interface of the node 4.4.4.6, in version 2 and priority 0;
it has been active for 39 minutes and 50 seconds and shall
expire in one minute and 40 seconds; the advertisement
interval is 60 seconds and holdtime is 150 seconds.
virtual interface of the node 4.4.4.6, in version 2 and priority 0;
it has been active for 39 minutes and 50 seconds and shall
expire in one minute and 40 seconds; the advertisement
interval is 60 seconds and holdtime is 150 seconds.