3com 8807 Guia De Referência

C

HAPTER

 43: VRRP C

ONFIGURATION

 C

OMMANDS

If the simple or md5 authentication is configured, it is required to set the 
authentication key.

This command is used to configure the authentication type and key for all the 
VRRP virtual routers on an interface. As defined in the protocol, all the virtual 
routers on an interface shall use the same authentication type and key. And all the 
members joining the same virtual router shall also use the same authentication 
type and key.

Note that the authentication key is case sensitive.

# Specify the authentication type and key for a VRRP virtual router.

[3Com-vlan-interface2] vrrp authentication-mode simple 3com 

System view

None

Use the vrrp log-state command to enable debugging of state transition logs of 
the VRRP virtual router.

Use the undo vrrp log-state command to disable debugging of state transition 
logs of the VRRP virtual router.

Note that if you enable VRRP debugging after executing the vrrp log-state 
command, the system does not output the state transition log of the VRRP virtual 
router because the information is the same as the debugging information.

By default, debugging of state transition logs of the VRRP virtual router is disabled.

# Enable debugging of VRRP state transition logs.

<SW8800> system-view

 

System View: return to User View with Ctrl+Z. 

 

[SW8800] vrrp log-state 

vrrp method { real-mac | virtual-mac }