3com 2226 PLUS Guia Do Utilizador
B
S
AFETY
I
NFORMATION
Important Safety Information
Please read the following safety information carefully
before installing the 3Com Baseline Switch 2226 Plus.
before installing the 3Com Baseline Switch 2226 Plus.
WARNING: Installation and removal of the unit must
be carried out by qualified personnel only.
be carried out by qualified personnel only.
WARNING: If installing the Switch unit in a stack with
other units, the Switch unit must be installed below
the narrower units and above the deeper units.
other units, the Switch unit must be installed below
the narrower units and above the deeper units.
WARNING: The unit must be earthed (grounded) to
ensure compliance with safety standards.
ensure compliance with safety standards.
WARNING: The appliance coupler (the connector to
the unit and not the wall plug) must have a configu-
ration for mating with an EN60320/IEC320 appliance
inlet.
the unit and not the wall plug) must have a configu-
ration for mating with an EN60320/IEC320 appliance
inlet.
WARNING: The socket outlet must be near to the
unit and easily accessible. You can only remove
power from the unit by disconnecting the power cord
from the outlet.
unit and easily accessible. You can only remove
power from the unit by disconnecting the power cord
from the outlet.
WARNING: This unit operates under SELV (Safety
Extra Low Voltage) conditions according to IEC 60.
The conditions are only maintained if the equipment
to which it is connected also operates under SELV
conditions.
Extra Low Voltage) conditions according to IEC 60.
The conditions are only maintained if the equipment
to which it is connected also operates under SELV
conditions.
WARNING: France and Peru only
This unit cannot be powered from IT
†
supplies. If your
supplies are of IT type, this unit must be powered by
230 V (2P+T) via an isolation transformer ratio 1:1,
with the secondary connection point labelled Neutral,
connected directly to earth (ground).
230 V (2P+T) via an isolation transformer ratio 1:1,
with the secondary connection point labelled Neutral,
connected directly to earth (ground).
†
Impédance à la terre
WARNING: Power cord set
This must be approved for the country where it will
be used.
be used.
U.S.A. and Canada
■
The cord set must be UL-approved
and CSA certified.
and CSA certified.
■
The minimum specifications for the
flexible cord are:
flexible cord are:
No. 18 AWG
Type SV or SJ
3-conductor
■
The cord set must have a rated cur-
rent capacity of at least 10 A.
rent capacity of at least 10 A.
■
The attachment plug must be an
earth-grounding type with a NEMA
5-15P (15 A, 125 V) or NEMA 6-15P
(15 A, 250 V) configuration.
earth-grounding type with a NEMA
5-15P (15 A, 125 V) or NEMA 6-15P
(15 A, 250 V) configuration.
Denmark
The supply plug must comply with Sec-
tion 107-2-D1, Standard DK2-1a or
DK2-5a.
tion 107-2-D1, Standard DK2-1a or
DK2-5a.
Switzerland
The supply plug must comply with
SEV/ASE 1011.
SEV/ASE 1011.