3com nj200 Guia Do Programa
3 C O M
®
N J 2 0 0 N E T W O R K J A C K — S N M P T R A P S
3Com NJ200 Network Jacks come bundled with 3Com Central Configuration Manager.
Designed for in-depth configuration and remote management of these devices, this tool
can be installed on a standalone PC or in the same system as the network management
platform. NJ200 switches use SNMP Version 1 (RFC-1157) and support four standard
SNMP traps: link up, link down, cold start, and authentication failure.
Designed for in-depth configuration and remote management of these devices, this tool
can be installed on a standalone PC or in the same system as the network management
platform. NJ200 switches use SNMP Version 1 (RFC-1157) and support four standard
SNMP traps: link up, link down, cold start, and authentication failure.
To enable and configure SNMP traps on an NJ200 Network Jack:
1. Open Central
Configuration Manager
and using either the IP or MAC address,
locate the NJ200 Netowrk Jack to be configured.
2. If the device is not on the initial list, begin a new discover
process by clicking on the
Discovery
icon from the toolbar.
3. Once the device has been located, select
Device Property
to open a window with
four tabs. Clicking on the
SNMP Settings
tab opens a window that looks like this:
3
Configuration and Setup
The 3Com Central Configuration Manager GUI
enables point-and-click remote administration of
NJ200 Network Jacks.
enables point-and-click remote administration of
NJ200 Network Jacks.