3com nj200 Guia Do Utilizador

 

Installing the Network Jack consists of the following steps:

 

Set up the power supply (page 5).

 

If necessary, set the Power Over Ethernet dip switches (page 7; optional, required 
only if your network supports Power Over Ethernet or if you are using a single-port 
or multi-port power supply).

 

Install the adapter plate and pass-through ports (page 8).

 

Plan the installation (page 9).

 

Set up the network cabling at your site (page 10).

 

Connect the Network Jack to the network (page 10).

 

Mount the Network Jack to the wall or office cubicle (page 11).

 

Connect the local power supply (page 11; optional) not required if your network 
supports Power Over Ethernet or if you are using a single-port or multi-port power 
supply).

 

Connect network devices to the Network Jack (page 13).

The following diagram displays an overview of the recommended installation, 
where the Network Jack is being connected to an Ethernet network cable that is 
terminated with a female RJ-45 connector. Detailed installation instructions are 
included in the sections that follow.

 

Power to the Network Jack can be supplied one of the following ways:

 

Over the network via an integrated switch that supports Power Over Ethernet.

 

Over the network via a multi-port Ethernet power supply.

 

Over the network via a single-port Ethernet power supply.

 

Locally via a 3Com local power supply.