Xerox 200e Instrução De Instalação
5
4-Mbyte RAM SIMM Installation — (4690F4M)
Note
For the PXi image processor: Install memory modules in the order J6
and then J7.
and then J7.
PXi image processor:
Insert a DRAM SIMM in connector J6 (or in J7 if
J6 is already filled) (
a
), and tilt the module upright until it locks in
place (
b
). Repeat Step 4 to install additional memory modules.
When properly inserted, a tab on each end of the connector slips into a
hole on each end of the RAM SIMM. Also, a pawl on each end of the
connector latches around each end of the RAM SIMM to lock it
in place.
hole on each end of the RAM SIMM. Also, a pawl on each end of the
connector latches around each end of the RAM SIMM to lock it
in place.
5.
Reinstall the EMI shield and the top panel.
6.
Reconnect the host interface cables. Turn on the printer and make a
print to ensure that the printer functions correctly.
print to ensure that the printer functions correctly.
J6
J7
J8
AppleTalk
®
Input
Serial
(RS-232)
Status
SCSI Disk
Parallel
Reset
Extended
Power Up
Run
Metric
American
Variable
1
2
3
4
5
6
7
8
9
Diagnostics
Paper Size
1200
Baud Rate
Skip
Run
Startjob
PHASER II PXi
MODEL 4694PXI
a
b
4