Xerox 300x Manual Do Utilizador

Página de 175
6
Troubleshooting
6-4
Phaser 300X Color Printer
Jam — Paper long
The paper is too long.  Remove the jammed paper.  
Use shorter paper.
Jam — Paper narrow
The paper is too narrow.  Remove the jammed paper.  
Use wider paper.
Jam — Paper short
The paper is too short.  Remove the jammed paper. 
Use longer paper.
Printing
No user action required.
Processing data
No user action required.
Pull ink load lever
After you add an ink stick, close the ink cover and pull 
down the ink load lever.
Ready
No user action required.  The printer is ready to print.
Standby
Press 
TEST PRINT
 to bring the printer to Ready.
Stopped — Add < color >
The printer needs ink of this color.  Add another 
ColorStix ink stick.
Stopped — Add paper
Add paper, or install the paper tray.
Stopped — Close rear door
Close the rear cover.
Stopped — Close top door
Close the top cover.
Stopped — Close waste bin
Close the waste bin.
Stopped — Empty waste bin
The waste bin needs to be emptied, or was replaced 
too quickly after being emptied.
Stopped — For hand feed
Insert paper for manual feed.
Stopped — Remove < color > The printer does not need ink of this color.  Remove the 
ink stick.
System failure.  Service 
required
Turn the printer off then on again.  If the failure persists, 
note the code number in the display and call your 
dealer, or Tektronix service in the U.S. only at 
1-800-547-8949.
Utilities
The printer is in Utilities mode.  You can use this mode 
to set the language on the front panel, clean the printer, 
check the copy (print) count, empty the waste bin, clean 
the fuser, and adjust head convergence.
Wait to add < color >
Wait up to 15 minutes before adding another ink stick.
Waiting for Data
No user action required.
Error codes and front panel messages (cont'd.)
Message
Action