Gestetner cs331 Manual Do Serviço
1
2
3
4
5
6
7
8
9
10
11
12
7-8
SELECTING FINISHING MODES (USING THE OPTIONAL FINISHERS)
2
Place the original(s).
Page 2-9
3
Press the key on the basic screen as shown on the
right (shaded).
Number of punch holes and available paper sizes:
Since the number of punch holes and the distance between
the holes vary depending on the country, purchase a punch
unit that meets your requirements. (For details, consult your
service technician.)
Since the number of punch holes and the distance between
the holes vary depending on the country, purchase a punch
unit that meets your requirements. (For details, consult your
service technician.)
4
Press the HOLE PUNCH key.
- If the key for the desired function is not shown, press the
Next key to switch the screen.
Select other copy modes as required.
5
Press the START key.
5. HOLE PUNCHING MODE
1
Place paper in the drawer(s).
Page 2-4
- When using this mode in bypass copying (
Page 6-5),
be sure to specify the paper size.
With the optional punching unit attached to the optional finisher (SR930, SR940), you can have your
copies punched with holes.
* The paper weight should be in the range of 17 lb. bond to 140 lb. index. Special paper such as OHP
copies punched with holes.
* The paper weight should be in the range of 17 lb. bond to 140 lb. index. Special paper such as OHP
films or labels is excluded.
North America
(Hole Punch Unit Type 3131)
Number of punch holes and hole diameter
2/3 holes switchable
(8.0 mm dia.)
Available paper sizes
2 holes: LG, LT-R,
3 holes: LD, LT