Arecont Vision av10005 Guia Do Utilizador

ARECONT VISION USER MANUAL

Arecont Vision 425 E Colorado St, 7

Floor Glendale, CA 91205 Revised 5/9/2010

www.arecontvision.com

AV Application Manager

After the software installation is complete, a shortcut to the AV Application Manager will appear on the user’s
Desktop.  All  programs  and  utilities  comprising  the  AV100  Video  System  can  be  launched  from  the  AV
Application  Manager.  By  default,  the  installation  will  include  the  Camera  Installer,  Video  System,  and  AVI
Maker.

Figure 8. Application manager

The AV Application Manager selections include:

Camera Installer

Camera Installer ---- setup cameras (see pg.15).

Video

Video System

System

System ---- watch live video (see pg.20).

AVI Make

AVI Makerrrr ---- make video clips from archive (see pg.44).

Camera Installer

The  Camera  Installer  is  a  utility  for  discovering  Arecont  Vision  cameras  that  are  present  on  the  local  area
network  and  assigning  IP  addresses  to  the  cameras.    The  assigned  IP  address  is  stored  on  camera,  and
maintained  when  the  power  is  off.    The  camera’s  IP  can  only  be  changed  through  one  of  the  following
methods: via the Camera Installer, via 3

party software, via a web browser using the camera’s webpage, or

via a HTTP command.
There are two supported modes of operation of the Camera Installer – Basic and Advanced. To start the
Camera Installer press the Run button under Camera Installer.

Camera Installer.

Basic Mode

In basic mode, the camera Installer detects all Arecont Vision cameras that can be reached by a broadcast
request  sent  over  the  network  by  the  computer  running  the  Camera  Installer.    It  automatically  assigns  IP
addresses  to  these  detected  cameras,  selecting  addresses  that  belong  to  the  same  sub-network  as  the
computer running the camera Installer and those which are not assigned to other network devices. To detect
and  install  the  cameras  automatically,  click  on  “Install  Cameras”.  The  installer  will  detect  any  cameras,