ONKYO bd-sp807 Guia Do Utilizador

If the unit does not perform properly when operated as instructed in this manual, check the unit, consulting the 
following checklist.

No power

-  Check if the AC cord is properly connected.
-   Unplug the AC cord once, and wait for 5-10 seconds and then plug it in again.

No sound or picture

-  Check if the connected TV is turned on.
-   Check if the connections are made securely and correctly.
-   Check whether the connected TV or other device supports HDCP. (This unit will 

not output a video signal unless the other device supports HDCP.)

-   Check whether the output format of this unit (HDMI FORMAT) matches the 

supported input format of other connected device.

-   When this unit is connected to the DVI jack on your TV or AV receiver, you 

cannot hear any sound from the HDMI OUT if your TV or AV receiver only 
supports DVI.

-   When the display device does not support the desired video resolution, set 

"HDMI Video Resolution" to "Auto".

-   If "HDMI Video Resolution" is set to "Source Direct", it may take a while to display 

the playback picture, when the video resolution of a disc material switches 
during playback.

Distorted picture

-   Sometimes a small amount of picture distortion may appear.
  This is not a malfunction.
-   Connect this unit directly to the TV. If the RCA audio / video cables are 

connected to a VCR, pictures may be distorted due to the copy right protection 
system.

Completely distorted picture or 
black / white picture with BD / DVD

-  Make sure the disc is compatible with this unit.

No sound or distorted sound

-  Adjust the volume.
-  Check that the speakers are connected correctly.
-  Check the HDMI connections.
-  Check the settings in “Audio” menu.

Picture freezes momentarily 
during playback

-   Check the disc for fingerprints / scratches and clean with a soft cloth wiping 

from center to edge.

-  Clean the disc.

Disc cannot be played back

-  Clean the disc.
-  Ensure the disc label is facing up.
-  Check if the disc is defective by trying another disc.
-  Cancel the ratings control or change the control level.
-  Insert a correct disc that can be played back on this unit.

SD Memory Card cannot be read. -   The format of the card does not match to this unit or the card is not compatible.
No return to start-up screen 
when disc is removed

-  Reset this unit by turning it off, then on again.

The unit does not respond to the 
remote control

-   Aim the remote control directly at infrared sensor window on the front panel.
-  Reduce the distance to infrared sensor window.
-  Replace the batteries in the remote control.
-   Re-insert the batteries with their polarities (+ / - signs) as indicated.
-   Check if a strong light source is not interfering with this unit's infrared sensor. 

Make sure that the unit is not subjected to direct sunshine or inverter-type 
fluorescent lights. Relocate if necessary.

-   If the BD player is installed in a cabinet with colored glass doors, the remote 

control may not work reliably when the doors are closed. Open the doors, or use 
a cabinet without colored glass.

Buttons do not work or the unit 
stops responding

-   To completely reset the unit, unplug the AC cord from the AC outlet for 5-10 

seconds.

The unit does not respond to 
some operating commands 
during playback

-   Operations may not be permitted by the disc.
  Refer to the instructions of the disc.

The unit cannot read BD / DVD / 
CD

-  Condensation? (Let sit 1 or 2 hours)
-   You are attempting to playback a disc other than one with one of the marks on 

page 19.

-  Wipe the dirt off the disc or replace the disc.