ONKYO dv-sp504 Guia Do Utilizador

 

11

 

• If the remote controller doesn’t work reliably, try 

replacing both batteries.

• Don’t mix new and old batteries, or different types of 

batteries.

• If you intend not to use the remote controller for a long 

time, remove the batteries to prevent possible leakage 
and corrosion.

• Flat batteries should be removed as soon as possible to 

prevent possible leakage and corrosion.

To use the remote controller, point it at the DVD player’s 
remote control sensor, as shown below.

 

• The remote controller may not work reliably if the 

DVD player is subjected to bright light, such as direct 
sunlight or inverter-type fluorescent lights. Keep this 
in mind when installing the DVD player.

• If another remote controller of the same type is used in 

the same room, or the DVD player is installed close to 
equipment that uses infrared rays, the remote control-
ler may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.

• The remote controller may not work reliably if the 

DVD player is installed in a rack behind colored glass 
doors. Keep this in mind when installing the DVD 
player.

• The remote controller will not work if there’s an obsta-

cle between it and the DVD player’s remote control 
sensor.

30˚

30˚

Appro

x.

 16 ft.

 (5 m)

Remote control sensor

DVD player

DV-SP504E_En.book Page 11 Monday, August 28, 2006 4:25 PM