ONKYO HT-S5200 Manual Do Utilizador

45

This section explains functions that can be used with any 
input source.

You can adjust the brightness of the display.

You can temporarily mute the output of the AV receiver.

To unmute the AV receiver, press the remote 
controller’s [MUTING] button again, or adjust the 
volume. The output is unmuted and the MUTING 
indicator goes off.
Muting is cancelled when the AV receiver is set to 
Standby.

With the sleep timer, you can set the AV receiver so that 
it turns off automatically after a specified period.

To cancel the sleep timer, press the [SLEEP] button 
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP] 
button. Note that if you press the [SLEEP] button while 
the sleep time is being displayed, you’ll shorten the sleep 
time by 10 minutes.

Press the [RECEIVER] button, 
and then press the remote 
controller’s [DIMMER] button 
repeatedly to select: dim, 
dimmer, or normal brightness.
You can also use the AV receiver’s 
[DIMMER] button.

Press the [RECEIVER] button, 
and then press the remote 
controller’s [MUTING] button.
The output is muted and the MUTING 
indicator flashes on the display.

Press the [RECEIVER] button, 
and then press the remote 
controller’s [SLEEP] button 
repeatedly to select the required 
sleep time.
You can set the sleep time from 90 to 10 
minutes in 10 minute steps.
The SLEEP indicator appears on the 
display when the sleep timer has been 
set, as shown. The specified sleep time 
appears on the display for about 5 
seconds, then the previous display 
reappears.

SLEEP indicator

HT-S5200_En.book  45 ページ  ２００９年３月９日　月曜日　午後４時３１分