ONKYO ht-s3400 Manual Do Utilizador

En

■

■

■

■

■

■

u functions don’t work

■

The following settings can be made for the 
composite video inputs
You must use the buttons on the unit to make these 
settings.
On the AV receiver, press the input selector for the 
input source that you want to set and the SETUP button 
simultaneously. While holding down the input selector 
button, press SETUP until “Video ATT:ON” appears 
on the display. Then, release both buttons. To reactivate 
the setting, repeat the above process so that “Video 
ATT:OFF” appears on the display, and release the 
buttons.

This setting can be made for the BD/DVD, VCR/DVR, 
CBL/SAT, GAME, or AUX input.
If you have a games console connected to the composite 
video input, and the picture isn’t very clear, you can 
attenuate the gain.
Video ATT:OFF: (default).
Video ATT:ON: Gain is reduced by 2 dB.

■

If the picture on your TV/monitor connected to 
HDMI OUT is unstable, try switching the 
DeepColor function off
To turn off the DeepColor function, simultaneously 
press the CBL/SAT and 

8 ON/STANDBY buttons on 

the AV receiver. While holding down CBL/SAT, press 
8 ON/STANDBY until “Off” appears on the display. 
Then, release both buttons. To reactivate the DeepColor 
function, repeat the above process until “On” appears 
on the display and release the buttons.

Always pause iPod/iPhone playback before selecting 
a different input source. If playback is not paused, 
the Direct Change function may select your 
iPod/iPhone as the input source by mistake during 
the transition between tracks.

—

On your recorder, make sure the correct input is 
selected.

—

To prevent signal loops and damage to the AV 
receiver, input signals are not fed through to outputs 
with the same name (e.g., VCR/DVR IN to 
VCR/DVR OUT).

—

In the following cases, the power consumption may 
reach up to a maximum of 31 W:
1.

You are using the Universal Port jack.

2.

“HDMI Ctrl (RIHD)” setting is set to “On”. 
(Depending on the TV status, the AV receiver 
will enter Standby mode as usual.)

34, 38

When a pair of headphones is connected, the 
listening mode is set to Stereo, unless it’s already set 
to Stereo, Mono, or Direct.

—

Use the “Input Ch (Mux)” setting on the “Audio 
Adjust” menu to select “Main” or “Sub”.

To use 

u, you must make an u connection and 

an analog audio connection (RCA) between the 
component and AV receiver, even if they are 
connected digitally.

The AV receiver contains a microcomputer for signal 
processing and control functions. In very rare situations, 
severe interference, noise from an external source, or 
static electricity may cause it to lockup. In the unlikely 
event that this happens, unplug the power cord from the 
wall outlet, wait at least five seconds, and then plug it 
back in again.

Onkyo is not responsible for damages (such as CD 
rental fees) due to unsuccessful recordings caused by 
the unit’s malfunction. Before you record important 
data, make sure that the material will be recorded 
correctly.

Before disconnecting the power cord from the wall 
outlet, set the AV receiver to Standby.