ONKYO HT-S5500 Manual Do Utilizador

If you connect a component to a digital audio input, you 
must assign that input to an input selector. For example, if 
you connect your CD player to the OPTICAL IN 1, you 
must assign “OPTICAL1” to the “TV/CD” input selector.
Here are the default assignments.

■

BD/DVD, VCR/DVR, CBL/SAT, GAME, AUX, 
TV/CD

`

COAXIAL1, COAXIAL2, OPTICAL1, 
OPTICAL2:

Select the input to which the component has been 
connected.

`

- - - - -:

Select if the component is connected to an analog 
audio input.

• When  an  HDMI IN is assigned to an input selector in 

“HDMI Input” (

), the same HDMI IN will be set as 

a priority in this assignment. In this case, if you want to use the 
coaxial or optical audio input, make the appropriate selection in 
the “Audio Selector” (

).

• Supported sampling rates for PCM signals (stereo/mono) from a 

digital input (optical and coaxial) are 32/44.1/48/88.2/96 kHz/16, 
20, 24 bit.

• The  “TUNER” selector cannot be assigned and is fixed at the 

“- - - - -” option.

Here you can check the settings made by Audyssey 2EQ 
Room Correction and Speaker Setup, or set them manually, 
which is useful if you change one of the connected 
speakers after using Audyssey 2EQ Room Correction and 
Speaker Setup.
This section explains how to specify which speakers are 
connected and their sizes.

For speakers with a cone diameter larger than 6-1/2 inches 
(16 cm), specify Large (full band). For those with a 
smaller diameter, specify Small (default crossover 
100 Hz).
The crossover frequency can be changed in the “Crossover 
(Crossover Frequency)” (

).

• These settings are not available in either of the following cases:

– A pair of headphones is connected.
– The  “Audio TV Out” setting is set to “On” (

– “HDMI Ctrl (RIHD)” is set to “On” (

) and you’re 

listening through your TV speakers.

■

`

`

■

`

`

Large:

Select based on the cone diameter.

• If the “Subwoofer” setting is set to “No”, this setting is fixed to 

“Large”.

■

`

`

Large:

Select based on the cone diameter.

`

■

`

`

Large:

Select based on the cone diameter.

`

None 

■

`

`

Large:

Select based on the cone diameter.

`

*1

If the “Front” setting is set to “Small”, the “Large” option 
cannot be selected.

*2

If the “Surround” setting is set to “None”, this setting cannot 
be selected.

*3

If the “Surround” setting is set to “Small”, the “Large” 
option cannot be selected.

*4

If the “Surround Back” setting is set to other than “None”, 
this setting is set to “None”.

*5

If the “Front High” setting is set to other than “None”, this 
setting is set to “None”.

Some of the settings in this section are set automatically 
by Audyssey 2EQ

®

 Room Correction and Speaker Setup 

).

Cone diameter