ONKYO ht-s7200 Manual Do Utilizador

36

With 

u (Remote Interactive), you can use the follow-

ing special functions:

■ Auto Power On/Standby

When you start playback on a component connected 
via 

u, if the AV receiver is on Standby, it will auto-

matically turn on and select that component as the 
input source. Similarly, when the AV receiver is set 
to Standby, all components connected via 

u will 

also go on Standby.

■ Direct Change

When playback is started on a component connected 
via 

u, the AV receiver automatically selects that 

component as the input source.

■ Remote Control

You can use the AV receiver’s remote controller to 
control your other 

u-capable Onkyo components, 

pointing the remote controller at the AV receiver’s 
remote control sensor instead of the component. You 
must enter the appropriate remote control code first 
(see page 89).

Notes:
• Use only 

u cables for u connections. u cables 

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two 

u jacks. You can con-

nect either one to the AV receiver. The other jack is for 
connecting additional 

u-capable components.

• Connect only Onkyo components to 

u jacks. Con-

necting other manufacturer’s components may cause a 
malfunction.

• Some components may not support all 

u functions. 

Refer to the manuals supplied with your other Onkyo 
components.

• While Zone 2 is on, the Auto Power On/Standby and 

Direct Change 

u functions do not work.

• Plug the end of the power cord into a suitable wall out-

let.

• Turning on the AV receiver may cause a momentary 

power surge that might interfere with other electrical 
equipment on the same circuit. If this is a problem, 
plug the AV receiver into a different branch circuit.

u Components

Step 1:
Make sure that each Onkyo component is connected 
to the AV receiver with an analog audio cable (con-
nection 

 in the hookup examples) (see pages 26 to 

Step 2:
Make the 

u connection (see illustration below).

Step 3:
If you’re using an RI Dock, change the Input Display 
(see page 44).