ONKYO ht-s9300thx Manual Do Utilizador
11
En
Connections
Connecting the AV Receiver
Speaker Configuration
The following table indicates the channels you should use
depending on the number of speakers that you have.
For 7.1-channel surround-sound playback, you need 7
speakers and a powered subwoofer.
depending on the number of speakers that you have.
For 7.1-channel surround-sound playback, you need 7
speakers and a powered subwoofer.
*1
If you’re using only one surround back speaker, connect it to
the SURR BACK OR FRONT HIGH L terminals.
the SURR BACK OR FRONT HIGH L terminals.
*2
Front high and surround back speakers cannot be used at the
same time.
same time.
*3
(North American models) When you connect the front high
left and right speakers, prepare for it separately, or use the sur-
round back left and right speakers.
left and right speakers, prepare for it separately, or use the sur-
round back left and right speakers.
No matter how many speakers you use, a powered sub-
woofer is recommended for a really powerful and solid
bass.
To get the best from your surround sound system, you
need to set the speaker settings. You can do this automati-
cally (
woofer is recommended for a really powerful and solid
bass.
To get the best from your surround sound system, you
need to set the speaker settings. You can do this automati-
cally (
39).
Speaker Connection Precautions
Read the following before connecting your speakers:
• You can connect speakers with an impedance of between
• You can connect speakers with an impedance of between
6 and 16 ohms. If you use speakers with a lower imped-
ance, and use the amplifier at high volume levels for a
long period of time, the built-in amp protection circuit
may be activated.
ance, and use the amplifier at high volume levels for a
long period of time, the built-in amp protection circuit
may be activated.
• Disconnect the power cord from the wall outlet before
making any connections.
• Read the instructions supplied with your speakers.
• Pay close attention to speaker wiring polarity. In other
• Pay close attention to speaker wiring polarity. In other
words, connect positive (+) terminals only to positive (+)
terminals, and negative (–) terminals only to negative (–)
terminals. If you get them the wrong way around, the
sound will be out of phase and will sound unnatural.
terminals, and negative (–) terminals only to negative (–)
terminals. If you get them the wrong way around, the
sound will be out of phase and will sound unnatural.
• Unnecessarily long, or very thin speaker cables may
affect the sound quality and should be avoided.
• Be careful not to short the positive and negative wires.
Doing so may damage the AV receiver.
• Make sure the metal core of the wire does not have con-
tact with the AV receiver’s rear panel. Doing so may
damage the AV receiver.
damage the AV receiver.
• Don’t connect more than one cable to each speaker ter-
minal. Doing so may damage the AV receiver.
• Don’t connect one speaker to several terminals.
Connecting Your Speakers
Number of channels
2
3
4
5
6
7
7
8
9
Front speakers
✔ ✔ ✔ ✔ ✔ ✔ ✔ ✔ ✔
Center speaker
✔
✔ ✔ ✔ ✔ ✔ ✔
Surround speakers
✔ ✔ ✔ ✔ ✔ ✔ ✔
Surround back speaker
*1*2
✔
✔
Surround back speakers
*2
✔
✔
Front high speakers
*2*3
✔ ✔ ✔