ONKYO ht-s9300thx Manual Do Utilizador

En

Using Audyssey 2EQ to create a listening environment in 
your home theater that all listeners will enjoy, 
Audyssey 2EQ takes measurements at up to 3 positions 
within the listening area. Position the microphone at ear 
height of a seated listener with the microphone tip pointed 
directly at the ceiling using a tripod. Do not hold the 
microphone in your hand during measurements as this will 
produce inaccurate results. 

a First measurement position

Also referred to as the Main Listening Position this 
refers to the most central position where one would 
normally sit within the listening environment. 2EQ 
uses the measurements from this position to calculate 
speaker distance, level, polarity, and the optimum 
crossover value for the subwoofer.

b Second measurement position

The right side of the listening area.

c Third measurement position

The left side of the listening area.

The distances from position 

a to b and a to c must be 

at least 1 meter.

• Make the room as quiet as possible. Background noise and Radio 

Frequency Interference (RFI) can disrupt the room measure-
ments. Close windows, televisions, radios, air conditioners, flu-
orescent lights, home appliances, light dimmers, or other 
devices. Turn off the cell phone (even if it is not in use) or place 
it away from all audio electronics.

• The microphone picks up test tones which played through each 

speaker as Audyssey 2EQ Room Correction and Speaker Setup 
run.

• Audyssey 2EQ Room Correction and Speaker Setup cannot be 

performed while a pair of headphones is connected.

TV

c ab

: Listening area

a to c: Listening position

Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV 
receiver is connected.

a, and connect it to the 

The speaker setting menu appears.

• The on-screen setup menus appear only on a TV that is 

connected to the HDMI OUT. If your TV is connected 
to the MONITOR OUT V or the COMPONENT 
VIDEO OUT, use the AV receiver’s display when 
changing settings.

If you use a powered subwoofer, adjust the sub-
woofer volume level to 75 dB.
Test tones are played through the subwoofer. Use 
the volume control on the subwoofer.

• If you set the subwoofer’s volume control to its maxi-

mum and the displayed level is lower than 75 dB, leave 
the subwoofer’s volume control at its maximum and 
press ENTER to proceed to the next step.

Audyssey 2EQ Room Correction and Speaker 
Setup starts.
Test tones are played through each speaker as 
Audyssey 2EQ Room Correction and Speaker 
Setup runs. This process takes a few minutes. 
Please refrain from talking during measurements 
and do not stand between speakers and the micro-
phone.
Do not disconnect the speaker setup microphone 
during Audyssey 2EQ Room Correction and 
Speaker Setup, unless you want to cancel the 
setup.

Audyssey 2EQ performs more measurements. 
This takes a few minutes.

Speaker setup microphone

SETUP MIC jack