ONKYO ht-s9100thx Manual Do Utilizador

 

103

 

• Reliable operation with an HDMI-to-DVI adapter is 

not guaranteed. In addition, video signals from a PC 
are not supported (page 35).

• If the message “Resolution Error” appears on the AV 

receiver’s display, this indicates that your TV does not 
support the current video resolution and you need to 
select another resolution on your DVD player.

 

• Relocate your antenna.
• Move the AV receiver away from your TV or com-

puter.

• When listening to an AM station, operating the remote 

controller may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

antenna.

 

• Make sure that the batteries are installed with the cor-

• Make sure that the remote controller is not too far 

away from the AV receiver and there’s no obstruction 
between the remote controller and the AV receiver’s 
remote control sensor (page 17).

• Make sure you’ve selected the correct remote control-

ler mode.

• Make sure you’ve entered the correct remote control 

 

• Make sure you’ve selected the correct remote control-

ler mode.

• If you’ve connected an 

-capable Onkyo MD 

recorder, CD recorder, or RI Dock to the TAPE 
IN/OUT jacks, or an RI Dock to the CBL/SAT IN 
jacks, for the remote controller to work properly, you 
must set the Input Display to MD, CDR, or DOCK, 
respectively (see page 48).

• The entered remote control code may not be correct. If 

more than one code is listed, try each one.

• With some AV components, certain buttons may not 

work as expected, and some may not work at all.

• To control an Onkyo component that’s connected via 

, point the remote controller at the AV receiver. Be 

sure to enter the appropriate remote control code first 
(page 93).

• To control an Onkyo component that’s not connected 

via 

, or another manufacturer’s component, point 

the remote controller at that component. Be sure to 
enter the appropriate remote control code first 
(page 92).

 

• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT or 
VCR/DVR IN to VCR/DVR OUT).

 

• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, or Direct, in which case it stays the same.

 

• On the Audio Adjust menu, change the Input Ch set-

 

• To use 

, you must make an 

 connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 40).

 

You must use the buttons on the AV receiver to change 
this setting.
1. While holding down the input selector button for the 

input source that you want to set, press the [SETUP] 
button.

2. Use the Left and Right [

]/[

] buttons to change 

the setting.

3. Press the [SETUP] button when you’ve finished.

 

This setting can be made for the DVD, VCR/DVR, 
CBL/SAT, or AUX input.
If you have a game console connected to an S-Video 
or composite video input, and the picture isn’t very 
clear, you can attenuate the gain.

 

 (default).

 

 Gain is reduced by 2 dB.

HT-S9100THX_En.book Page 103 Friday, June 27, 2008 4:00 PM