ONKYO ht-s9100thx Manual Do Utilizador

 

35

 

■

 

Digital video signals received by the HDMI IN jacks are normally output by the HDMI OUT for display on your TV. 
Composite video, S-Video, and component video sources are upconverted and, depending on the resolution of your TV, 
upscaled for output by the HDMI OUT. See “Video Connection Formats” on page 27 and the “Video Resolution Chart” 
on page 107 for more information.

 

■

 

Digital audio signals received by the HDMI IN jacks are output by the speakers and headphones connected to the AV 
receiver. Normally, they are not output by the HDMI OUT.

To listen to audio received by the HDMI IN jacks through your TV’s speakers, set the Audio TV Out 
setting to On (see page 90), and set your DVD player’s HDMI audio output setting to PCM.

 

• The HDMI video stream is compatible with DVI (Digital Visual Interface), so TVs and displays with a DVI input can 

be connected by using an HDMI-to-DVI adapter cable. (Note that DVI connections only carry video, so you’ll need 
to make a separate connection for audio.) However, reliable operation with such an adapter is not guaranteed. In 
addition, video signals from a PC are not supported.

• To listen to an HDMI source component through the AV receiver, you must configure your system so that video from 

the HDMI source component can be displayed on your TV (i.e., on your TV, select the HDMI input that’s connected 
to the AV receiver’s HDMI OUT). This is necessary because a component identification check has to be performed 
on your TV before an HDMI source component can output any signals. If your TV is off or set to a different input 
source, the AV receiver may produce no sound or the sound may be distorted.

• The HDMI audio signal (sampling rate, bit length, etc.) may be restricted by the connected source component. If the 

picture is poor or there’s no sound from a component connected via HDMI, check its setup. Refer to the connected 
component’s instruction manual for details.

Step 1: Use HDMI cables to connect the AV receiver’s HDMI jacks to your HDMI-compatible DVD player, TV, 
projector, and so on.

Step 2: Assign each HDMI IN to an input selector in the HDMI Input Setup (see page 46).

HT-S9100THX_En.book Page 35 Friday, June 27, 2008 4:00 PM