ONKYO ht-s5600 Guia Do Utilizador

• You can cancel Audyssey 2EQ Room Correction and Speaker 

Setup at any point in this procedure simply by disconnecting the 
setup microphone.

• Do not connect or disconnect any speakers during Audyssey 2EQ 

Room Correction and Speaker Setup.

• If the AV receiver is muted, it will be unmuted automatically 

when Audyssey 2EQ Room Correction and Speaker Setup starts.

• Changes to the room after Audyssey 2EQ Room Correction and 

Speaker Setup requires you run Audyssey 2EQ Room Correction 
and Speaker Setup again, as room EQ characteristics may have 
changed.

While Audyssey 2EQ

®

 Room Correction and Speaker 

Setup is in progress, one of the error messages below may 
appear.

The options are:

`

Retry:

Try again.

`

Cancel:

Cancel Audyssey 2EQ Room Correction and Speaker 
Setup.

The background noise is too loud. Remove the source of 
the noise and try again.

The number of speakers detected was different from that 
of the first measurement. Check the speaker connection.

This message appears if saving fails. Try saving again. If 
this message appears after 2 or 3 attempts, contact your 
Onkyo dealer.

This message appears if a speaker is not detected. “No” 
means that no speaker was detected.

• See “Speaker Configuration” for appropriate settings 

(

You can manually make changes to the settings found 
during Audyssey 2EQ Room Correction and Speaker 
Setup.
See also:
• “4. Sp Config (Speaker Configuration)” (

)

• “5. Sp Distance (Speaker Distance)” (

• “6. Level Cal (Level Calibration)” (

)

If you’re using a powered subwoofer and it outputs very 
low-frequency sound at a low volume level, it may not be 
detected by Audyssey 2EQ Room Correction and Speaker 
Setup.
If the “Subwoofer” appears on the “Review Speaker 
Configuration” screen as “No”, increase the subwoofer’s 
volume to the half-way point, set it to its highest crossover 
frequency, and then try running Audyssey 2EQ Room 
Correction and Speaker Setup again. Note that if the 
volume is set too high and the sound distorts, detection 
issues may occur, so use an appropriate volume level. If the 
subwoofer has a low-pass filter switch, set it to Off or 
Direct. Refer to your subwoofer’s instruction manual for 
details.

• You can view the calculated settings for the speaker 

configuration, speaker distances, and speaker levels by 

using 

e/r.

q/w to select a target, and use e/r to change 

the setting.
After the results of Audyssey 2EQ have been saved, 
the menu will display the “Audyssey” (

), “Dynamic Volume” 

(

• When  “Audyssey Quick Start” has been used for 

measurement, “Audyssey” cannot be selected.

• These settings are applied to all input selectors.

Error message