ONKYO ht-s5600 Guia Do Utilizador

■

■

• The Auto Standby function turns the subwoofer on when the 

input signal exceeds a certain level. If the Auto Standby function 
does not work reliably, try slightly increasing or decreasing the 
subwoofer output level on your receiver.

We recommend using the supplied rubber stoppers to 
achieve the best possible sound from your speakers. The 
rubber stoppers prevent the speakers from moving, 
providing a more stable platform. Use rubber stoppers for 
the center speaker.

If the subwoofer is placed on a hard floor (wood, vinyl, 
tile, etc.) and playback is very loud, the subwoofer’s feet 
may damage the flooring. To prevent this, place the 
supplied pads underneath the subwoofer’s feet. The pads 
also provide a stable base for the subwoofer.

To set the level of the subwoofer, use the 
OUTPUT LEVEL control. Set it so that bass 
sounds are evenly balanced with the treble sounds 
from the other speakers. Because our ears are less 
sensitive to very low bass sounds, there’s a temptation to 
set the level of the subwoofer too high. As a rule of thumb, 
set the subwoofer level to what you think is the optimal 
level, and then back it off slightly.

To mount the front/surround/surround back speakers 
vertically, use the keyhole slot shown to hang each speaker 
on a screw that’s securely screwed into the wall.

To mount the center speaker horizontally, use the two 
keyhole slots shown to hang the speaker on two screws that 
are securely screwed into the wall.

• If the center speaker is tilted, loosen the screw on the declined 

side to move upward so that the speaker could be adjusted 
vertically.

Status indicator
Off: Subwoofer in standby mode or 

disconnected from power source

Blue: Subwoofer on
With the Auto Standby function, the 
SKW-591 automatically turns on when 
an input signal is detected in standby 
mode. When there’s no input signal for 
a while, the SKW-591 automatically 
enters standby mode.

SKW-591

To AC outlet

OUTPUT LEVEL control
This control is used to adjust the 
volume of the subwoofer.

LINE INPUT
This RCA input should be 
connected to the subwoofer pre 
out on your AV receiver with 
supplied RCA cable.

SKW-591

Rubber stoppers

Bottom of the 
SKC-591N/SKC-591

Pad

SKF-591

SKR-590/SKB-590

Keyhole slots for 

wall mounting

Keyhole slots for wall mounting

7-7/8" (200 mm)

SKC-591N/
SKC-591