ONKYO TX-NR1000 Manual De Instruções
138
Using the Remote Controller with Other Components
—Continued
Running Macros
Programmed macros can be run as follows.
Naming Macros
You can name your macros as follows. Names may con-
tain of up to five characters.
tain of up to five characters.
1
Press the [MACRO] button.
2
Roll the scroll wheel to select the
macro’s number, and then press
the scroll wheel.
macro’s number, and then press
the scroll wheel.
The actions in the macro are per-
formed in the order in which they were
programmed.
formed in the order in which they were
programmed.
1
Press and hold the [CUSTOM] but-
ton for more than three seconds.
ton for more than three seconds.
The remote controller enters Custom
mode.
mode.
2
Roll the scroll wheel to select
“MACRO,” and then press the
scroll wheel.
“MACRO,” and then press the
scroll wheel.
3
Roll the scroll wheel to select
“NAME,” and then press the scroll
wheel.
“NAME,” and then press the scroll
wheel.
4
Roll the scroll wheel to select the
number of the macro that you want
to name, and then press the scroll
wheel.
number of the macro that you want
to name, and then press the scroll
wheel.
CUSTOM
Macro #1 selected
1st character
5
Roll the scroll wheel to select a
character, and then press the
scroll wheel to set it.
character, and then press the
scroll wheel to set it.
The following characters are available.
0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K
L M N O P Q R S T U V W X Y Z + – = < >
_ ¯¯ / \ * space
L M N O P Q R S T U V W X Y Z + – = < >
_ ¯¯ / \ * space
6
Repeat step 5 until you’ve entered
all 5 characters.
all 5 characters.
The previous menu reappears.
If the name you are entering consists of
less than five characters, enter spaces at
the end to the end to fill all five places.
If the name you are entering consists of
less than five characters, enter spaces at
the end to the end to fill all five places.
Macro #1 selected
1st character set