ONKYO TX-NR3007 Guia Do Utilizador

135

Note:
This procedure can also be performed on the AV receiver 
by using its [SETUP] button, arrow buttons, and 
[ENTER] button.

■ Zone2/3 Out
If you’ve connected your Zone 2/3 speakers to an amp 
with no volume control, set the “Zone2 Out” and “Zone3 
Out” setting, respectively, to “Variable” so that you can 
set the volume, balance, and tone of zone 2/3 on the AV 
receiver.

■ Zone2/3 Maximum Volume
With this setting, you can limit the maximum volume for 
Zone 2/3. When the “Volume Display” setting is set to 
“Absolute”, the “Maximum Volume” range is 50 to 99. 
When it’s set to “Relative”, the range is –32 dB to 
+17 dB. To disable this setting, select “Off”.

■ Zone2/3 Power On Volume
This setting determines what the volume will be for 
Zone 2/3 each time the AV receiver is turned on.
When the “Volume Display” preference is set to “Abso-
lute”, the range is “Last”, “Min”, 1 to 99, or “Max”. 
When it’s set to “Relative”, the range is “Last”, –

Q dB, 

–81 dB to +18 dB.
To use the same volume level as when the AV receiver 
was last turned off, select “Last”.
The “Zone2/3 Power On Volume” cannot be set higher 
than the “Zone2/3 Maximum Volume” setting.

Press the [RECEIVER] button 
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] 

buttons to select “7. Hardware 
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.

q]/[w] 

buttons to select “2. Multi Zone”, 
and then press [ENTER].
The “Multi Zone” menu appears.

q]/[w] 

e]/[r] 

buttons to change it.
The items are explained below.

When you’ve finished, press the
[SETUP] button.
The setup menu closes.

Fixed: The Zone 2/3 volume must be set on the 

amp in that zone (default).

Variable: The Zone 2/3 volume can be set on the AV 

receiver.