ONKYO TX-NR3007 Guia Do Utilizador

47

With 

u (Remote Interactive), you can use the follow-

ing special functions:

■ Auto Power On/Standby

When you start playback on a component connected 
via 

u, if the AV receiver is on Standby, it will auto-

matically turn on and select that component as the 
input source. Similarly, when the AV receiver is set 
to Standby, all components connected via 

u will 

also go on Standby.

■ Direct Change

When playback is started on a component connected 
via 

u, the AV receiver automatically selects that 

component as the input source.

■ Remote Control

You can use the AV receiver’s remote controller to 
control your other 

u-capable Onkyo components, 

pointing the remote controller at the AV receiver’s 
remote control sensor instead of the component. You 
must enter the appropriate remote control code first 
(see page 142).

Notes:
• Use  only 

u cables for u connections. u cables 

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two 

u jacks. You can con-

nect either one to the AV receiver. The other jack is for 
connecting additional 

u-capable components.

• Connect only Onkyo components to 

u jacks. Con-

necting other manufacturer’s components may cause a 
malfunction.

• Some components may not support all 

u functions. 

Refer to the manuals supplied with your other Onkyo 
components.

• While Zone 2 or Zone 3 is on, the Auto Power 

On/Standby and Direct Change 

u functions do not 

work.

• Turning on the AV receiver may cause a momentary 

power surge that might interfere with other electrical 
equipment on the same circuit. If this is a problem, 
plug the AV receiver into a different branch circuit.

• Do not use a power cord other than the one supplied 

with the AV receiver. The supplied power cord is 
designed exclusively for use with the AV receiver and 
should not be used with any other equipment.

• Never disconnect the power cord from the AV receiver 

while the other end is still plugged into a wall outlet. 
Doing so may cause an electric shock. Always discon-
nect the power cord from the wall outlet first, and then 
the AV receiver.

u Components

Step 1:
Make sure that each Onkyo component is connected 
to the AV receiver with an analog audio cable (con-
nection 

 in the hookup examples) (see pages 35 to 

Step 2:
Make the 

u connection (see illustration right).

Step 3:
If you’re using an MD, CDR, or RI Dock, change the 
Input Display (see page 60).

Step 1: 
Connect the supplied power cord to the AV receiver’s 
AC INLET.

Step 2:
Plug the power cord into an AC wall outlet.