ONKYO TX-NR801 Manual De Instruções

 

7

 

The worldwide model has a voltage selector for com-
patibility with power systems around the world. Before 
you plug in this model, make sure that the voltage selec-
tor is set to the correct voltage for your area. If it isn’t, 
use a small screwdriver to set it appropriately. For 
example, if the voltage in your area is 120 volts (V), set 
the selector to “120V.” And if it’s between 220 and 230 
volts (V), set it to “220-230V.”

 

• The supplied batteries should last for about six 

months, although this will vary with usage.

• If the remote controller doesn’t work reliably, try 

replacing both batteries.

• Don’t mix new and old batteries, or different types of 

batteries.

• If you intend not to use the remote controller for a 

long time, remove the batteries to prevent possible 
leakage and corrosion.

• Dead batteries should be removed as soon as possible 

to prevent possible leakage and corrosion.

To use the remote controller, point it at the TX-NR801/
TX-NR801E’s remote control sensor, as shown below. 
The TX-NR801/TX-NR801E’s STANDBY indicator 
flashes while a signal is being received from the remote 
controller.

 

• The remote controller may not work reliably if the 

TX-NR801/TX-NR801E is subjected to bright light, 
such as direct sunlight or inverter-type fluorescent 
lights. Keep this in mind when installing the 
TX-NR801/TX-NR801E.

• If another remote controller of the same type is used 

in the same room, or the TX-NR801/TX-NR801E is 
installed close to equipment that uses infrared rays, 
the remote controller may not work reliably.

• Don’t put anything, such as a book, on the remote 

controller, because the buttons may be pressed inad-
vertently, thereby draining the batteries.

• The remote controller may not work reliably if the 

TX-NR801/TX-NR801E is installed in a rack behind 
colored glass doors. Keep this in mind when install-
ing the TX-NR801/TX-NR801E.

• The remote controller will not work if there’s an 

obstacle between it and the TX-NR801/
TX-NR801E’s remote control sensor.