ONKYO TX-SR501 Manual Do Utilizador

24

This chapter explains basic settings that you need to make in 
order to enjoy your TX-SR501/TX-SR501E after turning it 
on for the very first time. These include, assigning input 
sources to digital inputs, specifying the number of speakers, 
and setting the subwoofer mode, as explained on pages 24 
and 25.

Before connecting the power cord, connect all your speakers 
and AV components (see page 10 to page 21).

With this function you can assign AV components (i.e., input 
sources) with digital audio outputs to the TX-SR501/
TX-SR501E’s digital inputs. You only need to change these 
assignments if your connections don’t match the default 
assignments listed in the following table. 

If, for example, you connect your DVD player’s coaxial dig-
ital audio output to the TX-SR501/TX-SR501E’s COAXIAL 
DIGITAL INPUT, you’ll need to change the DVD input 
source assignment from OPTICAL 1 to COAXIAL.

You can change the assignments as follows.

Turning on the TX-SR501/TX-SR501E 
may cause a momentary power surge that 
might interfere with other electrical 
equipment on the same circuit. If this is a 
problem, plug the TX-SR501/
TX-SR501E into a different branch cir-
cuit.

The TX-SR501/TX-SR501E enters 
Standby mode, and the STANDBY indi-
cator comes on.

Notes:
• The TX-SR501/TX-SR501E is shipped 

with the [POWER] switch in the ON 
position.

• To completely shutdown the 

TX-SR501/TX-SR501E, press the 
[POWER] switch.

• The remote controller has no effect 

while the [POWER] switch in the OFF 
position.

The TX-SR501/TX-SR501E comes on, 
the display lights up, and the STANDBY 
indicator goes off.

To turn off the TX-SR501/TX-SR501E, 
press the [STANDBY/ON] button. The 
TX-SR501/TX-SR501E will enter 
Standby mode. To prevent any loud sur-
prises the next time you turn on your 
TX-SR501/TX-SR501E, always turn 
down the volume before turning it off.

OPTICAL 1

Not assigned

OPTICAL 2

Not assigned

Not assigned

COAXIAL

The selected source appears on the dis-
play. (The value next to the input source is 
the volume setting.)

The current source assignment appears, as 
shown.