ONKYO TX-SR606 Manual De Instruções

 

98

 

• Reliable operation with an HDMI-to-DVI adapter is 

not guaranteed. In addition, video signals from a PC 
are not supported (page 31).

• If the message “Resolution Error” appears on the AV 

receiver’s display, this indicates that your TV does not 
support the current video resolution and you need to 
select another resolution on your DVD player.

 

• Relocate your antenna.
• Move the AV receiver away from your TV or com-

puter.

• When listening to an AM station, operating the remote 

controller may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

antenna.

 

• Make sure that the batteries are installed with the cor-

• Make sure that the remote controller is not too far 

away from the AV receiver and there’s no obstruction 
between the remote controller and the AV receiver’s 
remote control sensor (page 13).

• Make sure you’ve selected the correct remote control-

ler mode.

• Make sure you’ve entered the correct remote control 

 

• Make sure you’ve selected the correct remote control-

ler mode.

• If you’ve connected an 

-capable Onkyo MD 

recorder, CD recorder, or RI Dock to the TAPE 
IN/OUT jacks, or an RI Dock to the GAME/TV IN 
jacks, for the remote controller to work properly, you 
must set the Input Display to MD, CDR, or DOCK, 
respectively (see page 45).

• The entered remote control code may not be correct. If 

more than one code is listed, try each one.

• With some AV components, certain buttons may not 

work as expected, and some may not work at all.

• To control an Onkyo component that’s connected via 

, point the remote controller at the AV receiver. Be 

sure to enter the appropriate remote control code first 
(page 88).

• To control an Onkyo component that’s not connected 

via 

, or another manufacturer’s component, point 

the remote controller at that component. Be sure to 
enter the appropriate remote control code first 
(page 87).

 

• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT or 
VCR/DVR IN to VCR/DVR OUT).

• When the Pure Audio listening mode is selected, video 

recording is not possible because no video signals are 
output. Select another listening mode.

 

• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, or Pure Audio, in which case it stays the 
same.

 

• On the “Audio Adjust” menu, change the “Input Ch” 

 

• To use 

, you must make an 

 connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 36).

• While Zone 2 is selected, the 

 functions don’t 

work.

 

• The display is turned off when the Pure Audio listen-

ing mode is selected. Select another listening mode.

TX-SR606_En.book Page 98 Friday, May 9, 2008 1:28 PM