ONKYO TX-SR604 Manual Do Utilizador

82

To Mute Zone 2:
Press the remote controller’s [ZONE 2] button, followed 
by the [MUTING] button. To unmute Zone 2, press the 
remote controller’s [ZONE 2] button again, followed by 
the [MUTING] button, or adjust the volume for Zone 2.

Notes:
• Only analog input sources are output by the ZONE 2 

LINE OUT and ZONE 2 SPEAKERS terminals. Dig-
ital input sources are not output. If no sound is heard 
when an input source is selected, check if it’s con-
nected to an analog input.

• While Zone 2 is being used, listening modes that need 

surround back speakers (i.e., Dolby Digital EX and 
DTS-ES) are unavailable.

• While Zone 2 is on, 

 functions will not work.

• You can’t select different radio stations for Zone 2 and 

the main room. For example, if you have an FM sta-
tion for the main room, that station will also be used 
in Zone 2.

To use the remote controller to control the AV receiver 
from Zone 2, you’ll need one of the following commer-
cially available multiroom remote control kits:
• Multiroom Kits are made by Niles and Xantech.
These kits can also be used when the AV receiver is not 
in line of sight of the remote controller, for example, 
when it’s installed inside a cabinet.

In the following diagram, an IR receiver picks up the 
infrared signals from the remote controller in Zone 2 and 
feeds them to the AV receiver in the main room via the 
connecting block.

Connect the miniplug cable from the connecting block to 
the AV receiver’s IR IN jack as shown below.

In the following diagram, an IR receiver picks up the 
infrared signals from the remote controller and feeds 
them to the AV receiver in the cabinet via the connecting 
block.

If your Zone 2 speakers are connected 
to an amp in Zone 2, use its volume 
control to adjust the volume.

Connecting 
block

Remote controller

IR receiver

Main room

Zone 2

Signal flow

from the connecting block

Miniplug cable

IR IN

Connecting 
block

Remote controller

IR receiver

Inside 
cabinet

Signal flow