ONKYO TX-SR607 Manual Do Utilizador

47

The onscreen setup menus appear only on a TV that is 
connected to the HDMI OUT. If your TV is connected 
to the MONITOR OUT V or the COMPONENT 
VIDEO OUT, use the AV receiver’s display when 
changing settings.

qwer

Notes:
• If any of your speakers is 4 ohms, change the 

“Speaker Impedance” setting before running the 
Audyssey 2EQ Room Correction and Speaker 
Setup (see page 43).

• If the AV receiver is muted, it will be unmuted 

automatically when the Audyssey 2EQ Room 
Correction and Speaker Setup starts.

• Room correction and speaker setup cannot be 

performed while a pair of headphones is 
connected.

• It takes about 15 minutes to complete the room 

correction and speaker setup for three positions. 
Total measurement time varies depending on the 
number of speakers.

• Do not disconnect the speaker setup microphone 

during the room correction and speaker setup, 
unless you want to cancel the setup.

• Do not connect or disconnect any speakers during 

the room correction and speaker setup.

Turn on the AV receiver and the 
connected TV.
On the TV, select the input to which the 
AV receiver is connected.

1

 (page 46), and connect it 

to the SETUP MIC jack.
The speaker setting menu appears.

If you change these settings, refer to 
step 5 on “Speaker Settings” (page 43) 
or step 4 on “Setting the Powered Zone 
2” (page 86).

Notes:
• Before starting Audyssey 2EQ

™

 

Room Correction and Speaker Setup, 
arrange the room and connect the 
speakers as you would for enjoying 
movies. Changes to the room after 
auto setup requires you run the auto 
setup again, as room EQ 
characteristics may have changed. 

• When starting the room correction 

and speaker setup, do not stand 
between the speakers and 
microphone, and avoid obstacles 
blocking the path between speakers 
and microphone. This will produce 
inaccurate results. 

• Position the microphone at ear height 

of a seated listener with the 
microphone tip pointed directly at 
the ceiling using a tripod. Do not 
hold the microphone in your hand 
during measurements as this will 
produce innacurate results.