ONKYO TX-SR607 Manual Do Utilizador

50

❏ Writing Error!

This message appears if saving fails.

Try saving again. If this message appears after 2 or 3 
attempts, the AV receiver is probably malfunctioning. 
Contact your Onkyo dealer.

Retry:  Return to step 2 and try again.

Cancel:  Cancel the room correction and speaker setup.

If you wish to make changes to the settings found during 
the room correction and speaker setup, follow the 
directions on pages 70–72.

If you’re using a powered subwoofer and it outputs very 
low-frequency sound at a low volume level, it may not be 
detected by the Audyssey 2EQ™ Room Correction and 
Speaker Setup.
If the “Subwoofer” appears on the “Review SP 
Configuration” screen as “No”, increase the subwoofer’s 
volume to the half-way point, set it to its highest 
crossover frequency, and then try running the 
Audyssey 2EQ Room Correction and Speaker Setup 
again. Note that if the volume is set too high and the 
sound distorts, detection issues may occur, so use an 
appropriate volume level. If the subwoofer has a low-
pass filter switch, set it to Off or Direct. Refer to your 
subwoofer’s instruction manual for details.