ONKYO TX-SR804 Guia De Configuração Rápida
SN 29344330
I0609-1
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.
* 2 9 3 4 4 3 3 0 *
Turning on & Using Automatic Speaker Setup
Selecting the Input Source
With the supplied speaker setup microphone, use the Automatic Speaker Setup function.
Before using this function, connect and position all your speakers.
Before using this function, connect and position all your speakers.
1
Press the [STANDBY/ON] button on the AV receiver or press the remote
controller’s [RECEIVER] button followed by the [ON] button to turn on
the AV receiver.
Turn on the TV and select the input to which the AV receiver is connected.
controller’s [RECEIVER] button followed by the [ON] button to turn on
the AV receiver.
Turn on the TV and select the input to which the AV receiver is connected.
2
Put the speaker setup microphone
in the listening position, and con-
nect it to the SETUP MIC jack on the
front panel.
And press [ENTER].
The automatic speaker setup starts.
The whole process takes about 2 minutes.
in the listening position, and con-
nect it to the SETUP MIC jack on the
front panel.
And press [ENTER].
The automatic speaker setup starts.
The whole process takes about 2 minutes.
3
When you’ve finished the setup,
press the Up and Down [
]/[
] but-
tons to select “Apply the Results,”
and then press [ENTER].
and then press [ENTER].
Disconnect the speaker setup
microphone.
microphone.
RECEIVER
STANDBY/ON
ON
Remote
controller
AV receiver
or
SETUP MIC
ENTER
MIC
position
position
Auto Speaker Setup
------------------------
Push Enter:Start
Push Enter:Start
Caution! Loud sound.
ENTER
ENTER
Auto Speaker Setup
------------------------
Apply the Results
Apply the Results
Check the Results
Retry
Retry with
Test noise Level up
Test noise Level up
Cancel
1.
Use the AV receiver’s input selector buttons
to select the input source.
To select the input source with the remote controller,
press the [RECEIVER] button, and then use the
INPUT SELECTOR buttons.
To select the input source with the remote controller,
press the [RECEIVER] button, and then use the
INPUT SELECTOR buttons.
2.
Start playback.
3.
To adjust the volume, use the MASTER VOL-
UME control, or the remote controller’s [VOL]
button.
button.
PUSH TO OPEN
STANDBY/ON
STANDBY
MASTER VOLUME
TAPE
ZONE 2
DISPLAY
PURE AUDIO
CD
TUNER
VIDEO 4
VIDEO 3
VIDEO 2
VIDEO 1
DVD
MULTI CH
PHONO
3
1
TX-SR804_DIG.fm Page 4 Friday, September 8, 2006 1:22 PM