ONKYO TX-SA806 Guia Do Utilizador

39

With 

u (Remote Interactive), you can use the follow-

ing special functions:

■ Auto Power On/Standby

When you start playback on a component connected 
via 

u, if the AV receiver/AV amplifier is on 

Standby, it will automatically turn on and select that 
component as the input source. Similarly, when the 
AV receiver/AV amplifier is set to Standby, all com-
ponents connected via 

u will also go on Standby.

■ Direct Change

When playback is started on a component connected 
via 

u, the AV receiver/AV amplifier automatically 

selects that component as the input source. If your 
DVD player is connected to the AV receiver/AV 
amplifier’s DVD multichannel input, you’ll need to 
press the [MULTI CH] button repeatedly and select 
“Multich” to hear all channels (see page 57), as the 
Direct Change 

u function selects the DVD 

FRONT L/R jacks.

■ Remote Control

You can use the AV receiver/AV amplifier’s remote 
controller to control your other 

u-capable Onkyo 

components, pointing the remote controller at the 
AV receiver/AV amplifier’s remote control sensor 
instead of the component. You must enter the appro-
priate remote control code first (see page 106).

Notes:
• Use  only 

u cables for u connections. u cables 

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two 

u jacks. You can con-

nect either one to the AV receiver/AV amplifier. The 
other jack is for connecting additional 

u-capable 

components.

• Connect only Onkyo components to 

u jacks. Con-

necting other manufacturer’s components may cause a 
malfunction.

• Some components may not support all 

u functions. 

Refer to the manuals supplied with your other Onkyo 
components.

• While Zone 2 is on, the Auto Power On/Standby and 

Direct Change 

u functions do not work.

• Turning on the AV receiver/AV amplifier may cause a 

momentary power surge that might interfere with 
other electrical equipment on the same circuit. If this 
is a problem, plug the AV receiver/AV amplifier into a 
different branch circuit.

• Do not use a power cord other than the one supplied 

with the AV receiver/AV amplifier. The supplied 
power cord is designed exclusively for use with the 
AV receiver/AV amplifier and should not be used with 
any other equipment.

• Never disconnect the power cord from the AV 

receiver/AV amplifier while the other end is still 
plugged into a wall outlet. Doing so may cause an 
electric shock. Always disconnect the power cord 
from the wall outlet first, and then the AV receiver/AV 
amplifier.

u Components

Step 1:
Make sure that each Onkyo component is connected 
to the AV receiver/AV amplifier with an analog audio 
cable (connection 

 in the hookup examples) (see 

Step 2:
Make the 

u connection (see illustration below).

Step 3:
If you’re using an MD, CDR, or RI Dock, change the 
Input Display (see page 50).

Step 1:
Connect the supplied power cord to the AV 
receiver/AV amplifier’s AC INLET.

Step 2:
Plug the power cord into an AC wall outlet.

TX-SR806_En.book  Page 39  Monday, August 4, 2008  10:25 AM