Plextor px-320a Guia Do Utilizador
Section 2. Installing Your PlexCombo
PlexCombo 20/10/40-12A Installation and Users Manual
19
3. Remove the cover panel from the bay that will hold the PlexCombo drive. To
remove the cover panel, pop it out by pressing outward lightly. (In some older
computers, you may have to remove screws that hold the panel in place.)
computers, you may have to remove screws that hold the panel in place.)
Figure 14: Removing the Cover Panel from a Bay
4. Determine if you must install mounting rails on the sides of your drive. To do so,
insert the drive into the open bay. If the drive fits tightly with little or no
clearance on either side of the drive, you will not have to use mounting rails. The
drive can be mounted directly into your computer. Go to step 6.
clearance on either side of the drive, you will not have to use mounting rails. The
drive can be mounted directly into your computer. Go to step 6.
NOTE: Plextor does not provide rails. If you need rails, you can obtain them from the
computer manufacturer or from a computer supply retail or mail-order store.
computer manufacturer or from a computer supply retail or mail-order store.
5. If you must use mounting rails, fasten the rails to the lower pair of holes as
shown in Figure 15. (In some instances, you may need to fasten the rails to the
upper set of holes.) After fastening the rails, check their positioning by sliding the
drive into the bay before you mount the drive or connect any cables.
upper set of holes.) After fastening the rails, check their positioning by sliding the
drive into the bay before you mount the drive or connect any cables.