Polycom 2W Guia Do Utilizador

SoundStation2W™ User Guide - 26

“No Signal” is displayed when the console loses contact 
with the base.  Verify the following:

► Check that the base station is 

powered up.

► Make sure that the console is 

not out of the allowed range 
(150 feet).

► Move the console to a location 

where there are fewer obstruc-
tions or walls between console 
and base station.

► If the console and base station 

are separated by multiple brick 
walls, this will reduce the avail-
able range between the base and 
console.

The base station must be plugged into an analog tele-
phone jack.  If the dial tone is not heard, verify the 
following:

► Check that the base is powered 

on.

► Check that the console is opera-

tional.

► Check that the base is con-

nected to an analog telephone 
(POTS) line.

► Check that the ringer is not 

turned off.  See “Ringer Type 
Selection”, page 15.

► Try increasing the ringer vol-

ume.

If your screen appears to flicker, 
it may be because you are using 
a certain type of florescent light-

ing in your building.  Move the 
SoundStation2W™ away from the 
lights.

This could happen if you enter infor-
mation too quickly.  Press the alphanu-
meric buttons more slowly.  

This is caused by highly reverberant rooms and people 
speaking too far from the microphone.

► Speak closer to the console so 

that the microphones pick up 
your speech more accurately.

►

 

Add more sound absorbency to 
the room.